Here is the easiest way to cancel your kitchen cabinets or any other cupboard.
- Win your old doors, as well as hinges and handles from old kitchen cabinets.
- Win front of the drawers of all the drawers. Keep the boxes aside. Be careful because usually two varieties drawer fronts. A variety that is simply connected to the drawer body can be removed by removing the attached drawers, paper clips or screws. The front part of the drawer, which is part of the drawer body, should be cut or peeled away, ensuring that the cut is square with the top, bottom and sides of the chassis.
- Cabinet preparation : Old screw holes or gaps in the frame, which must be filled with either a filler for the body or on a wooden filler, as well as for dry and fresh sanding. All areas that are reused using any product that prevents placement in the office should be cleaned from cracking paint, grease or varnish. You can use an automatic belt grinder or paint scraper to do this.
- If you have corner cupboard , you may need to insert a strip of filler. If you have a hole that is too large and you want to put a strip of filler, do it as soon as you clean the surface. Work with a piece of pine cut to size. Secure it with screws. Things in any seams with filler and sand even. In some cases, you will need to cross sections using a 1/4 "core (i.e. lower cabinet). Side-out vykrylyvanie must be shaved or filled with a stain using 1/8" skin or 1/4 "moon or plywood, to ensure surface area even in relation to lamination.
lamination
- Once all the frames clean and smooth , your laminate, facing body, wooden veneer or thermo-foil can be applied. In case you do work from the whole sheet of 2 characters, the skin cuts off the product belonging to the bottom of the cabinet and returns 1/4 of an inch more than is required. Make sure that the grain on the bottom of the kitchen cabinets on the wall is the same. The grain on the cupboard is returned to work vertically.
- laminate at the bottom of kitchen cabinets. Apply recommended recommended glue to each kitchen cabinet and cabinet partitions. If necessary, use a roller or brush. Let the glue dry the contact. Put on the cabinet by placing the skin on the surface of the kitchen cabinet. Keep in mind that after the product is installed on the cabinet, it cannot be rebuilt. Make full use of your good sense, as well as a hand-held roller or a block of solid wood, to level the laminate to the kitchen cabinet. Trim additional material using a saw, knife or router. Then the laminate returns cabinets using the same procedure.
- Make a kitchen cupboard turning the skin straight into strips for steels, as well as rails with grains going to the actual length of the strip. Once again, cut the strips 1/4 "larger than necessary.
- Laminated Kitchen Cabinet fronts. Make a cabinet application that places strips of leather in the same way as in the closet. First laminate the vertical steel elements, and then go to the horizontal rails. Hold all seams as far as possible.
- Instead of behaving in accordance with guidelines 4 and 5 above, you can use whole sheets of laminate Put it on the facades of the cabinet, then break through with the trimmer and router so that it can open the hole. Any procedure is suitable. The use of lanes will necessarily reduce the supply; masking the entire front of the kitchen cabinet with a whole sheet will certainly help save on work and will be in much better lamination, because absolutely no seams will appear on styles and rails.
- It does not matter what procedure used to shell the front kitchen cabinets, leave the cabin, leaving the overhanging skin at every time possible.
- Get rid of all extra oak, walnut or pine from cabinets with a saw, service knife or router
- Congratulations You have completed the lamination of the kitchen cabinet.
