Penis enlargement pumps are used by many men to increase the length and girth of the pants. Penis pumps work by creating a vacuum in a glass or plastic cylinder in which the penis is placed. When air pressure decreases in the cylinder, the penalty increases accordingly. In accordance with this external force, cells in the box will multiply in response, actually making themselves larger. Thus, by allowing the felon to remain in this state for extended periods of time, the punishment can be constantly increased.
How to choose a penis pump
When choosing a pump for penis enlargement, be sure to choose one with a cylinder that is too big or too small. If the cylinder is too large, your scrotum will be sucked during pumping, and if the cylinder is too small, it will not allow the penis to expand, thereby limiting the increase in girth. None of them is perfect.
Also, choose a penis pump that comes with a pressure gauge and a pressure valve so that you have better control over the pressure on your penis. The pressure gauge will allow you to control the pressure so that you are not subjected to excessive pressure, and the pressure shut-off valve allows you to quickly release the pressure of the pump with your finger. This setting is necessary if you want to minimize the risks associated with using a penis pump.
After you have taken the new pump (or received it by mail), be sure to thoroughly flush the cylinder with hot water and a small amount of liquid soap or dishwashing liquid.
Before and during each pumping session
Before pumping, you must shave off the area on the skin that comes into contact with the pump cylinder to achieve a good seal. Secondly, if you did not perform other penis exercises (for example, jelking) just before the transfer, you should do warm-ups so that the blood circulation passes in your penis to minimize the chance of damage during the transfer later. A simple warm-up exercise can be done by inserting a towel into hot, but not scaling water, squeeze the towel and wrap it around the penis for 2 minutes, and then repeat it at least 3 more times. While you are wrapping a hot towel, let the cylinder rinse quickly with hot water.
After warming up, stroke your penis until a half-screening or full evaluation. Apply several petroleum jelly on the contact area with the pump cylinder for a better seal. Then set the cylinder over your penis and gradually create it until you feel a little uncomfortable, but not painful. Never press on the pump to the point of pain if you do not want to risk permanent damage to your penis.
Keep the pump under pressure for ten minutes, during which you can do everything that is not associated with large movements, such as watching TV or surfing the net. After ten minutes, relieve the pressure in the cylinder, remove it from the penis, and massage the penis for at least three minutes to restore circulation. Then you can put the pump on for another ten minutes, then take out the pump and massage the penis for three minutes and repeat until your penis is flaccid (i.e. soft).
After a pumping session
After each penis pumping session, rewind the hot towel again, as described above, to re-circulate blood flow in your penis.
Every time you use a penis pump, you should wash the cylinder with hot water and a small amount of dishwashing detergent or liquid soap.
The risks associated with the use of penis pumps
A penis enlargement pump is a very risky device that can cause great damage to your penis even with all the solutions mentioned above. Increased pressure in the penis pump can lead to bruising or coagulation (also called “thrombosis”) of a vein or lymphatic vessel or other forms of (worse) damage that cannot be reversed. By buying only pumps that come with a manometer and safety valve, performing warm-up exercises before dropping, avoiding excessive pressure during pumping and taking frequent breaks during pumping, you can minimize the chance of injury. Therefore, take all precautions and be extremely careful.
During a pumping session, if you feel pain at any time, immediately release the pressure and remove the pump and do not pump out the pump for at least two days before resetting it again. If the pain persists, you are advised to immediately consult a doctor and honestly explain the situation so that he / she can help you.
If you see a donut-shaped ring or blister on your skin, stay away from pumping until they heal completely. Similarly, if you experience a thrombosis, avoid pumping out for a few weeks until it is completely healed. Do not try to squeeze the clot, as this will not heal it.
You are also advised to take at least two days. break for a maximum of every five days of swapping. Your penises need time to heal before permanent success can be achieved. If you miss these breaks, you will increase the chances of damaging your penis, as well as slow the progress made.
Top penis-pumping alternatives
Although many people can vouch for the effectiveness of penis pumping, there are safer penis enlargement methods that are just as effective if not more. You are encouraged to explore other ways to expand your penis. Manual penis exercises, such as jelqing, combined with the use of a good penis extender, can produce amazing results.
